Name: Dulux Trade Vinyl Silk Paint
Brand: dulux
SKU: BW-15484
Price: 24.73 GBP
Availability: InStock

Dulux Trade Vinyl Silk Paint - Variation Available.

Silk emulsion paint for use on interior walls and ceilings
Top quality washable emulsion based on unique AkzoNobel technology, providing a tough, mid-sheen finish
Tough, Washable Finish
High Opacity
Coverage up to 16m² Per Litre
Water-based
Drying time (recoat) : 2-4 hours
Drying time (touch dry) : Dependent on temperature and humidity
Suitable Surface : Walls, Drywall, Ceilings
General No. of Coats : 2
Chemical Resistance: Not suitable.
Heat Resistance: Not suitable for use on heated surfaces, such as radiators.
Water Resistance: Will tolerate the levels of atmospheric humidity present in normal interior environments and will withstand moderately vigorous washing.

£24.73^Each

SURFACE PREPARATION :
To get the best results, make sure surfaces to be painted are sound, clean, dry (new surfaces particularly must be fully dry).
Remove all loose and defective paint
Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
Where necessary, wash the surface to remove dirt, grease and powdery or dusty residues.
Rinse with clean water and allow to dry.
Seal surfaces that remain powdery after thorough preparation with an appropriate plaster sealer.
Where necessary, rub down and then wipe off with a damp, lint free cloth to avoid dust.
Any surface defects should be filled with the appropriate Polycell Trade Polyfilla.

SYSTEMS INFORMATION :
STIR THOROUGHLY BEFORE USE.
Seal new or bare surfaces with a thinned first coat (up to 1 part clean water to 5 parts paint).
The normal finishing process is 2 full coats of Dulux Trade Vinyl Silk, however for significant colour change additional coats may be required.
For best colour consistency, purchase sufficient tinted paint for each job including touch-in at one time from the same source.

APPLICATION METHOD :
Brush, roller, conventional spray or airless spray.
As with other water-based paints, do not apply at temperatures below 8 degree C (as recommended by British Standard BS 6150).
To minimise risk of picture framing or patchy finishes, we strongly recommend stirring the paint thoroughly prior to use.
If thinned, the paint used for cutting-in and for rolling should be to the same ratio. Cut in one wall at a time, then rolling immediately afterwards, not allowing the cutting-in to dry prior to rolling.
Cut in no more than 5 to 8cm away from any internal angles, including sockets/switches, skirting, architraves etc.
Roll into the cutting-in, ensuring you roll as close to the edge as possible.

Thinning :
Sealing new or bare surfaces: Add up to 1 part clean water to 5 parts paint.
Normal use (not to be exceeded): Add up to 1 part clean water to 10 parts paint.
Conventional spray application: Add up to 1 part clean water to 5 parts paint.
Airless spray application: Thinning is not required.

Spray Recommendations :
Conventional Spray: Satisfactory through most equipment.
Airless Spray: A typical set up for airless spray would be a minimum working pressure on paint of 133 bars (2000lb/sq in) with a spray tip size of 0.38mm (15 thou) and a spray tip angle of 65 degree.

Transportation Storage :
Do not use or store in extremes of temperature and protect from frost. To prevent spillage, please store and transport upright.

Dulux Trade Vinyl Silk Paint